张微敬, 张兵, 李振宝, 周宏宇. 强约束大尺寸钢筋混凝土柱抗震性能试验研究[J]. 工程力学, 2013, 30(12): 236-241. DOI: 10.6052/j.issn.1000-4750.2013.02.0123
引用本文: 张微敬, 张兵, 李振宝, 周宏宇. 强约束大尺寸钢筋混凝土柱抗震性能试验研究[J]. 工程力学, 2013, 30(12): 236-241. DOI: 10.6052/j.issn.1000-4750.2013.02.0123
ZHANG Wei-jing, ZHANG Bing, LI Zhen-bao, ZHOU Hong-yu. EXPERIMENTAL STUDY ON SEISMIC PERFORMANCE OF LARGE SCALE REINFORCED CONCRETE COLUMNS WITH STRONG CONFINEMENT[J]. Engineering Mechanics, 2013, 30(12): 236-241. DOI: 10.6052/j.issn.1000-4750.2013.02.0123
Citation: ZHANG Wei-jing, ZHANG Bing, LI Zhen-bao, ZHOU Hong-yu. EXPERIMENTAL STUDY ON SEISMIC PERFORMANCE OF LARGE SCALE REINFORCED CONCRETE COLUMNS WITH STRONG CONFINEMENT[J]. Engineering Mechanics, 2013, 30(12): 236-241. DOI: 10.6052/j.issn.1000-4750.2013.02.0123

强约束大尺寸钢筋混凝土柱抗震性能试验研究

EXPERIMENTAL STUDY ON SEISMIC PERFORMANCE OF LARGE SCALE REINFORCED CONCRETE COLUMNS WITH STRONG CONFINEMENT

  • 摘要: 为研究箍筋强约束钢筋混凝土柱的抗震性能,完成了6个配箍特征值0.34~0.44、截面尺寸450mm#x000d7;450mm的大尺寸钢筋混凝土柱试件的拟静力试验研究。结果表明,试件的破坏形态为压弯破坏,纵筋压曲甚至断裂,部分试件箍筋拉断,底部1倍柱截面高度范围内混凝土保护层剥落,箍筋约束核心区混凝土局部压碎。试件水平力-位移滞回曲线饱满,极限位移角达到1/39~1/33,延性系数均大于3.0。对于箍筋强约束柱,改变箍筋形式或改变箍筋肢距,对其正截面承载力及极限变形能力影响不大;相同位移往复加载由3次增加至5次,对其正截面承载力及峰值位移影响不大,但变形能力降低约15%。

     

    Abstract: To investigate the seismic performance of reinforced concrete columns with strong confinement, quasi-static tests on six full-scale reinforced concrete columns with stirrup characteristic values in the range of 0.34~0.44 and with section dimension 450mm#x000d7;450mm were conducted. The test results indicated that the failure modes of specimens were compression-bending; the longitudinal bars buckled in compression and even broke; several stirrups fractured. Within a height of one time of column depth above the column bottom the concrete cover spalled seriously and the confined concrete partially crushed. The lateral force-displacement hysteretic loops were plump, the ultimate drift ratios ranged from 1/39 to 1/33 and the ductility coefficients were greater than 3. Changing the stirrup types or changing the space of stirrup legs had little effects on the load-carrying capacity and ultimate deformation capacity of specimens. Increasing the number of lateral loading cycle from 3 to 5 had little effects on the load-carrying capacity and peak deformation of specimens, but led to about 15% decrease of the deformation capacity.

     

/

返回文章
返回