刘祖强, 薛建阳, 葛鸿鹏, 赵鸿铁. 实腹式型钢混凝土异形柱框架刚度与承载力试验研究[J]. 工程力学, 2013, 30(10): 86-92,107. DOI: 10.6052/j.issn.1000-4750.2012.06.0430
引用本文: 刘祖强, 薛建阳, 葛鸿鹏, 赵鸿铁. 实腹式型钢混凝土异形柱框架刚度与承载力试验研究[J]. 工程力学, 2013, 30(10): 86-92,107. DOI: 10.6052/j.issn.1000-4750.2012.06.0430
LIU Zu-qiang, XUE Jian-yang, GE Hong-peng, ZHAO Hong-tie. EXPERIMENTAL STUDY ON STIFFNESS AND LOADING CAPACITY OF SOLID STEEL REINFORCED CONCRETE FRAME WITH SPECIAL-SHAPED COLUMNS[J]. Engineering Mechanics, 2013, 30(10): 86-92,107. DOI: 10.6052/j.issn.1000-4750.2012.06.0430
Citation: LIU Zu-qiang, XUE Jian-yang, GE Hong-peng, ZHAO Hong-tie. EXPERIMENTAL STUDY ON STIFFNESS AND LOADING CAPACITY OF SOLID STEEL REINFORCED CONCRETE FRAME WITH SPECIAL-SHAPED COLUMNS[J]. Engineering Mechanics, 2013, 30(10): 86-92,107. DOI: 10.6052/j.issn.1000-4750.2012.06.0430

实腹式型钢混凝土异形柱框架刚度与承载力试验研究

EXPERIMENTAL STUDY ON STIFFNESS AND LOADING CAPACITY OF SOLID STEEL REINFORCED CONCRETE FRAME WITH SPECIAL-SHAPED COLUMNS

  • 摘要: 通过2榀实腹式配钢的型钢混凝土(SRC)异形柱框架的低周反复加载试验,获得其破坏特征和荷载-位移滞回曲线,分析其刚度和承载力。结果表明,实腹式配钢的SRC异形柱框架具有良好的抗震性能,破坏机制为梁铰机制;刚度退化由快到慢,呈现出较好的规律性;对SRC异形柱框架的弹性层刚度进行计算,结果与试验结果符合较好;承载力衰减随加载位移的增加而增大,但当位移小于5#x00394;y时,同级位移下承载力衰减较小;实腹式SRC异形柱框架的层间受剪承载力可采用柱底塑性铰法进行计算。

     

    Abstract: According to the experimental study on two frame models composed of reinforced concrete beams and solid steel reinforced concrete (SRC) special-shaped columns under low cyclic reversed loading, the failure pattern and load-displacement hysteretic loops were obtained, and the stiffness and loading capacity were analyzed. The results show that, solid SRC frames with special-shaped columns have excellent seismic performance, and the failure mechanism is the beam-hinged mechanism. The degradation speed stiffness of the structure chances from fast to slow, which shows good regulation. The elastic story stiffness of solid SRC frame with special-shaped columns is calculated, and the results are close to the test results. The strength degradation develops with the increase of displacement, but when the displacement is less than 5#x00394;y, the loading capacity degradation is not obvious under the same displacement. The method of plastic hinge forming at the column bottom is applicable for the calculation of story shear capacity of solid SRC frame with special-shaped columns.

     

/

返回文章
返回