Volume 34 Issue 12
Turn off MathJax
Article Contents
Abstract
References
YU Jin-guang, ZHENG Chun-ming, WANG Xue-jun, FENG Xiao-tian. EFFECT OF TRANSVERSE BRACES ON THE BEHAVIOR OF STEEL PLATE SHEAR WALL FRAME STRUCTURE[J]. Engineering Mechanics, 2017, 34(12): 192-201. DOI: 10.6052/j.issn.1000-4750.2016.10.0762
Citation: YU Jin-guang, ZHENG Chun-ming, WANG Xue-jun, FENG Xiao-tian. EFFECT OF TRANSVERSE BRACES ON THE BEHAVIOR OF STEEL PLATE SHEAR WALL FRAME STRUCTURE[J]. Engineering Mechanics, 2017, 34(12): 192-201. DOI: 10.6052/j.issn.1000-4750.2016.10.0762
shu

EFFECT OF TRANSVERSE BRACES ON THE BEHAVIOR OF STEEL PLATE SHEAR WALL FRAME STRUCTURE

  • School of Civil Engineering, Xi'an University of Architecture and Technology, Xi'an, Shaanxi 710055, China

More Information
  • Received Date: October 07, 2016
  • Revised Date: July 23, 2017
    Graphical Abstract
    • Abstract
  • It presents an investigation on the behavior of a steel plate shear wall frame structure strengthened by transverse braces. The horizontal parts of the crossed restrainers are connected to the boundary columns to act as the transverse braces in the structural system. Two 1/3 scale, one-bay, three-story frames with steel plate shear walls were tested under quasi-static cyclic loadings. The failure modes and hysteretic behavior of the specimens were compared and discussed. Deformation and stress concentration at the infilled steel plates, the boundary columns and the beam-to-column connections were also analyzed. The test results demonstrated that the steel plate shear wall frame with transverse braces exhibited better performance in terms of load carrying capacity, energy dissipation and stiffness. The incorporation of transverse braces in the steel plate shear wall frame could significantly reduce stress concentration at the beam-to-column connections and was effective to restrain the deformation of the boundary columns and the steel plate shear walls. Compared to the conventional steel plate shear wall frame, the pull-in deformation of the boundary columns was reduced by 20% with the addition of transverse braces. In addition, the noise and vibration of the steel plate shear walls in the frame under lateral loads were also improved with the contribution of transverse braces.
    • FullText(HTML)
    • References (17)
  • [1]
    Driver R G, Kulak G L, Laurie Kennedy D G, et al. Cyclic test of four-story steel plate shear wall[J]. Journal of Structural Engineering, 1998, 124(2):112-120.
    [2]
    Sabouri-Ghomi S, Gholhakia M. Ductility of thin steel plate shear wall[J]. Asian Journal of Civil Engineering, 2008, 9(2):2069-2077.
    [3]
    于金光, 郝际平. 半刚性连接钢框架-非加劲钢板剪力墙结构性能研究[J]. 土木工程学报, 2012, 45(8):74-82. Yu Jinuang, Hao Jiping. Study on behavior of semi-rigid connection steel frames with unstiffened steel shear wall structure[J]. China Civil Engineering Journal, 2012, 45(8):74-82. (in Chinese)
    [4]
    陈国栋, 郭彦林, 范珍, 等. 钢板剪力墙低周反复荷载试验研究[J]. 建筑结构学报, 2004, 25(2):19-26. Chen Guodong, Guo Yanlin, Fan Zhen, et al. Cyclic test of steel plate shear walls[J]. Journal of Building Structures, 2004, 25(2):19-26. (in Chinese)
    [5]
    Habashi H R, Alinia M M. Characteristics of the wall-frame interaction in steel plate shear walls[J]. Steel Construction, 2012, 66(2):150-158.
    [6]
    Lubell A S, Helmut G L, Ventura C E, et al. Unstiffened steel plate shear wall performance under cyclic loading[J]. Journal of Structural Engineering, 2000, 126(4):453-460.
    [7]
    Li C H, Tsai K C, Lin C H, et al. Cyclic tests of four two-story narrow steel plate shear walls——Parts two:Experimental results and design implication[J]. Earthquake Engineering and Structural Dynamics, 2010, 39(7):801-826.
    [8]
    郭彦林, 陈国栋, 缪友武. 加劲钢板剪力墙弹性抗剪屈曲性能研究[J]. 工程力学, 2006, 23(2):84-91. Guo Yanlin, Chen Guodong, Miao Youwu. Elastic buckling behavior of steel plate shear wall with cross or diagonal stiffeners[J]. Engineering Mechanics, 2006, 23(2):84-91. (in Chinese)
    [9]
    Sigariyazd M A, Joghataie A, Attari N K A. Analysis and design recommendations for diagonally stiffened steel plate shear walls[J]. Thin-Walled Structures, 2016, 103:72-80.
    [10]
    赵伟, 杨强跃, 童根树. 钢板剪力墙加劲肋刚度及弹性临界应力研究[J]. 工程力学, 2010, 27(6):15-23. Zhao Wei, Yang Qiangyue, Tong Genshu. Stiffener stiffness and elastic buckling stress of steel plate shear wall[J]. Engineering Mechanics, 2010, 27(6):15-23. (in Chinese)
    [11]
    JGJ/T380-2015, 钢板剪力墙技术规程[S]. 北京:中国建筑工业出版社, 2016. JGJ/T380-2015, Technical specification for steel plate shear walls[S]. Beijing:China Architecture & Building Press, 2016. (in Chinese)
    [12]
    杨嘉胤, 童根树, 张磊. 竖向闭口加劲钢板剪力墙在非均匀压力下的弹性稳定性研究[J]. 工程力学, 2015, 32(11):132-139. Yang Jiayin, Tong Genshu, Zhang Lei. Research of static buckling of steel shear walls stiffened by vertical tubes under nonuniform compression[J]. Engineering Mechanics, 2015, 32(11):132-139. (in Chinese)
    [13]
    Alavi E, Nateghi F. Experimental study on diagonally stiffened steel plate shear walls with central perforation[J]. Journal of Constructional Steel Research, 2013, 89(5):9-20.
    [14]
    Sabouri Ghomi S, Mamazizi S. Experimental investigation on stiffened steel plate shear walls with two rectangular openings[J]. Thin-Walled Structures, 2015, 86:56-66.
    [15]
    Guo H C, Li Y L, Liang G, et al. Experimental study of cross stiffened steel plate shear wall with semi-rigid connected frame[J]. Journal of Constructional Steel Research, 2017, 135:69-82.
    [16]
    Tsai K C, Li C H, Lin C H, et al. Cyclic tests of four two-story narrow steel plate shear walls——Part one:Analytical studies and specimen design[J]. Earthquake Engineering and Structural Dynamics, 2010, 39(7):775-799.
    [17]
    American Institute of Steel Construction (AISC), Seismic Provisions for Structural Steel Buildings[S]. Chicago, IL, 2005.
    • Related Articles

  • Cited by

    Periodical cited type(9)

    1. 袁昌鲁，杨宁，郭世江，李嘉锴，边广生. 修复后两边连接钢板剪力墙抗震性能研究. 四川建筑科学研究. 2023(03): 1-9 .
    2. 于金光，刘利明，郝际平. 部分组合框架-钢板剪力墙边框柱设计方法研究. 工程力学. 2020(02): 98-110 . 本站查看
    3. 刘海宾. 钢板剪力墙施工技术在超高层建筑中的应用. 山西建筑. 2020(06): 77-79 .
    4. 郝际平，吴博睿，于金光，于海升，杜一鹏. 钢板剪力墙震后型钢斜劲修复结构的抗震性能研究. 建筑结构学报. 2020(05): 43-52 .
    5. 王希政. 钢板剪力墙施工技术在某超高层建筑中的施工应用探究. 铁道建筑技术. 2019(06): 143-146 .
    6. 宗超. NM360耐磨钢板在备件制作中的运用. 中国金属通报. 2019(12): 89+91 .
    7. 兰涛，何浩，门进杰，宋昭，任如月，赵钿，王凌云. 箱板式钢结构模块单元的抗震性能模拟和抗侧力计算模型研究. 工业建筑. 2018(09): 22-27+21 .
    8. 刘青，李国强，曹轲，黄靖宇. 屈曲约束钢板剪力墙-钢框架的宏观单元模型. 建筑科学与工程学报. 2018(01): 102-110 .
    9. 殷占忠，李锦铭，赵帅鹏. 带PEC柱的钢板剪力墙结构抗震性能试验研究. 土木工程学报. 2018(S1): 139-144 .

    Other cited types(4)

Catalog

    Get Citation
    PDF
    XML

    Article Metrics

    Article views (269) PDF downloads (17) Cited by(13)
    Related

    京ICP备18030614号

    Copyright © 《工程力学》编辑部

    Address: North-Star Times Tower, No.8 Beichendong Road, Chaoyang District, Beijing, China China Pos: 100084

    Tel: (010)62788648 Fax: 021-64253812 Email: gclxbjb@tsinghua.edu.cn

    Supported by: Beijing Renhe Information Technology Co.,Ltd.  Baidu Analytics

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return